Parallel charging Board for 6 packs 2~6S (T Connector) CERAMIC COATED LONG LASTING MICRO SOLDERING IRON BIT - CB25N3 Basic Wiring: Connect one side

Basic Wiring: Connect one side to a GPIO pin (with a 10kOhm pull-up or pull-down resistor) and the other side to GND or VCC depending on your logic configuration

7V LiPo charger or USB charger with BMS compatibility

Discharge Cut-off Voltage: 2

maintaining proper cable shielding to minimize electromagnetic interference

Parallel charging Board for 6 packs 2~6S (T Connector) CERAMIC COATED LONG LASTING MICRO SOLDERING IRON BIT - CB25N3 Basic Wiring: Connect one sideParallel charging Board for 6 packs 2~6S (T Connector) The Parallel charging Board for 6 packs 2~6S is a specialized LiPo battery charging hub designed to simultaneously charge up to 6 lithium polymer batteries in parallel configuration using T connectors. This charging solution is essential for RC hobbyists, drone operators, and professional aerial photography teams who require rapid multi battery charging without sequential delays. It solves the