Graphtec CB15UA-K30 High Intensity Supersteel Blades 60° - 1.5mm Compatible With_Epson D700 Directions for use: After all

Directions for use: After all ink and tape have been removed

1-paper-system

cool-down mode for easier shut-down and fault detection on the exhaust

1" x 2" rectangle silicone printing pad

Graphtec CB15UA-K30 High Intensity Supersteel Blades 60° - 1.5mm Compatible With_Epson D700 Directions for use: After allGraphtec Supersteel Blades are angled 60 Diameter 1. 5mm Supersteel Blade for cutting rigid media, 0. 25 mm to 0. 5 mm thick. And also small detailed characters on marking film (up to 0. 25mm). Recommended blade for sand blast rubber resist media cutting and high intensity reflective sheeting. Note: CB15 K30 blade can be used with CE6000 Plus by selecting the CB15U under Tools, then performing a test cut looking for 90 degree corners, if needed adjust